CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C
)
Transition Module Preparation and Installation
Installing and Removing the Transition Module
140
7.7
Installing and Removing the Transition Module
Installation Procedure
After all peripheral modules have been installed and all of the appropriate jumpers have been
set, you are ready to install the transition module in its chassis slot. At this point, follow the steps
below:
1.
Attach an ESD strap to your wrist. Attach the other end of the strap to the chassis
as a ground. The ESD strap must be secured to your wrist and to ground throughout
the procedure.
2.
Perform an operating system shutdown. Turn the AC or DC power off and remove
the AC cord or DC power lines from the system. Remove the chassis or system
cover(s) as necessary for access to the chassis backplane.
3.
With the CPCI-6020-MCPTM-01 in the correct vertical position that matches the pin
positioning of the backplane, carefully slide the transition module into the
appropriate slot and seat tightly into the backplane.
4.
Secure in place with the screws provided, making good contact with the transverse
mounting rails to minimize RF emissions.
5.
Replace the chassis or system cover(s), reconnect the system to the AC or DC
power source and turn the equipment power on, or if hot swapping, you may now
install the CPCI-6020.
Personal Injury or Death
Dangerous voltages, capable of causing death, are present in this equipment.
Use extreme caution when handling, testing and adjusting.
Product Damage
Avoid touching areas of integrated circuitry; static discharge can damage these
circuits.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
