Motorola CDR500, Руководство по программированию

Страница: 82 / 104

11-4
6864110R66-O March, 2001
Programming the Professional Series Radios for use with a ZR340 Repeater Controller CDR500 & CDR700 Repeater Service Manual
Programming
NOTE (Cont’d.)
stability capability of the radio does not
meet the requirements of Part 90 of the
Rules and Regulations of the Federal
Communications Commission (FCC). In
other countries, check local frequency
stability requirements before placing a
Professional radio based repeater or base
station in operation.
16. Enter the transmit frequency for the repeater
in the “Rx” area at “Frequency (MHz)”.
17. Select the receiver “Squelch Type:” as “CSQ”
(Carrier SQuelch).
18. Enter the transmit frequency for the repeater
in the “Tx” area at “Frequency (MHz)”.
19. Select the transmitter “Squelch Type:” based
upon the type of operation that is required
(CSQ, TPL or DPL). Your screen should
appear similar to Figure 11-8.
20. Enter any other special programming require-
ments in the appropriate windows.
21. Assign the personality to a zone in the “Per-
sonality Assignment to Zone” selection win-
dows.
22. Program the transmit radio.
Ignition Sense Wiring
Adding the ignition sense lead to pin 10 of the 16-pin
connectors of the radios will ensure that the repeater
will automatically power-up whenever power is
applied. This is particularly important when the
repeater is mounted in a relatively inaccessible loca-
tion. Refer to Section 12, Ignition Sense Wiring, of this
manual.
NOTE
If you haven’t already done so, program
both of the radios for “Ignition Sense
Type:” as “On/Off & Ignition” or “Fol-
low Ignition Only” in the Accessory Con-
f i g u r a t i o n
w i n d o w ( i n R a d i o
Configuration).
ZR340 Advanced Telephone Interconnect
ZR340 Jumper Configurations
Set the internal jumper settings of the ZR340 according
to Table 11-1.
ZR340 Programming
The system and interconnect parameters of the ZR340
are programmed with DTMF commands. Refer to the
ZR340 Advanced Interconnect Instruction Manual, 68-
80905Z90, for detailed instructions and a list of com-
mands.
ZR340 Adjustments
Refer to the ZR340 Advanced Interconnect Instruction
Manual, 6880905Z90, for detailed instructions and a
list of commands for adjusting and aligning the ZR340
controller.
Figure 11-8. Conventional Personality, Basic,
Transmit Radio
Table 11-1. ZR340 Jumper Settings
Jumper Setting
JP7 B (16)
JP8 B (16)
JP9 A (8)
or
B (16)