Using the CA10
2 - 5
CA10 Status Indications
Indications during use
The
Private Reply
button has a backlight to provide visual feedback of the CA10 status when the CA10 is in use
(not charging).
The CA10 status indications are listed in
Table 2-1
.
Table 2-1
CA10 Status Indications
Profiles
The CA10 uses a profile to save a collection of configuration settings for the CA10. You can create or use a default
profile and load it on the CA10 as part of system deployment (see
Configuring the CA10 units on page 3-7
).
Resetting the CA10
If the CA10 is not functioning properly, turn off the CA10 and turn it on again (see
Powering on / off on page 1-8
). If
the CA10 does not respond, reset the CA10 to its factory default configuration.
Reset to factory default
To restore the CA10 to its factory default configuration:
1.
Place the CA10 onto the cradle.
2.
Simultaneously hold down the
Volume Down
button and
Advance
button until the CA10 beeps four times
followed by a fast stutter tune. The CA10 automatically restarts with factory default settings.
3.
Configure the CA10 (
Configuring the CA10 units on page 3-7
).
LED Status
Event
No light
CA10 is turned off.
Blinking green
•
Repeated slow blink: incoming Private Reply Call
•
Repeated fast blink: Private Reply Call is active
•
Single blink every 10 seconds: standby state
Blinking red
•
Repeated single blink: low power, re-charge the CA10
•
Repeated sequence of blinks: no wireless connection
Blinking amber
CA10 is powering-up.
Содержание CA10
Страница 1: ...CA10 User Guide ...
Страница 2: ...CA10 User Guide 72E 124942 01 Revision A August 2009 ...
Страница 5: ...iv CA10 User Guide ...
Страница 11: ...x CA10 User Guide ...
