Motorola APX 7500, Подробное руководство по обслуживанию

Страница: 49 / 164

68009482001 September 9, 2011
Installation: Programming the Consolette 3-7
ii. Setup of the internal Consolette controller card using a web browser to access the built-
in Configuration App.
NOTE: All programming can be accomplished without removal of the Consolette lid.
Prior to programming the Consolette, it is recommended that the Consolette be taken off-line. This
could include temporarily refraining from using the unit or physically disconnecting the unit from any
remote control source such as a Tone Remote Control deskset.
3.7.1 APX 7500 CPS Programming
The APX 7500 CPS application is used for set up of the transceiver features including transmit and
receive frequencies, the zones and channels, the conventional and trunking personalities, and the
O5 display. This requires the GCAI USB cable, HKN6184A, for connection between the PC and
either the GCAI connector on the O5 control head or on the auxiliary GCAI connector on the front
panel of the Consolette.
For details on the operation of the transceiver and its settings, refer to the APX 7500 Mobile Detailed
Service Manual (6875963M01) and the APX 7500 O5 Control Head Mobile Radio User Guide
(6875947M01). The transceiver codeplug supports additional features that are not applicable to
Consolette users including Siren operation, DVRS operation, and Multi-Control Head operation.
Default codeplugs have these features disabled and it is recommended that they remain disabled.
Additionally, the APX 7500 CPS application is used to Flash upgrade the O5 control head, the mobile
radio, and the Consolette controller card firmware – See
section 3.7.1.2 .
3.7.1.1 Radio CPS settings specific to Consolette
3.7.1.1.1 Programming the APX Consolette for Consolette Enabled
Consolette codeplugs should be configured as Consolette Enabled to ensure proper error reporting.
In APX Mobile CPS:
Radio Ergonomics Configuration
Æ
Radio Ergonomics Wide
Æ
Advanced Tab:
• Check - Consolette Enable
3.7.1.1.2 Programming the APX Consolette to pass MDC Data
In some Consolette configurations it may be desirable to configure the Consolette to pass the MDC
data burst to the external rear panel audio outputs (Wireline, Rx Audio, etc.) – For example, if MDC
ID's are viewed at the Front Panel control head display or if they are passed to a console via the
ACIM interface.
NOTE: With this configuration the MDC data burst will also be heard at the local speaker and
headset.
In APX Mobile CPS:
Conventional Configuration
Æ
Conventional System
Æ
Features Tab:
• Disable - Data Operated Squelch (DOS)
Conventional Configuration
Æ
Conventional Personality
Æ
Rx Options Tab:
• Rx Unmute Delay (ms) – Set this value to 0 or some value less than or equal to the “MDC
System Pretime” configured in the transmitting subscribers radios.