6A
6B
CMD
SET
SEL
5s
CMD
SET
SEL
CMD
SET
SEL
CMD
SET
SEL
CMD
SET
SEL
CMD
SET
SEL
CMD
SET
SEL
5s
6A
6B
EN
EN
1 •
Press the
SEL
and
SET
buttons simultaneously
for 5 sec. to access the
programming menu.
When you start the opening display shows
U
.
When you start the closing display shows
d
.
Opening indicator
Closing indicator
2 •
The display will show
F
.
Press the
SEL
button as
many times as necessary
until the display shows
P
.
3 •
Press the
SET
button to
start the course recognition.
During the course recognition, display shows
P
.
To make the opening and closing course programmation, the mechanical limit switches
must always be in tune.
1º
Unlock the motor;
2º
Manually, put the gate in closing position and adjust the closing limit switch;
3º
Manually, put the gate at the opening position you want and adjust the opening limit
switch.
05. FUNCTIONS
OPENING AND CLOSING COURSE PROGRAMMING
1 •
Press the
SEL
and
SET
buttons simultaneously
for 5 sec. to access the
programming menu.
4 •
Press the
SET
button
once to save this option.
2 •
The display will show
F
.
Press
SET
button to access
the submenu.
5 •
The display will show
F
and the configuration is
successfully done.
3 •
The display will show
a value between 1 and 9,
indicating the currently
configured level. Use
SEL
button to choose desired
option.
6 •
To exit the programming
mode wait 10 sec. until (–)
appears.
This menu allows to set the level of sensibility that you want in the motor operation.
Maximum sensibility - 1 | Minimum sensibility - 9
AUTOMATION SENSIBILITY PROGRAMMING
05. FUNCTIONS
4 •
If the door is open, it will close until it reaches the closing limit switch.
5 •
It will open slowly for 5 seconds to detect the force during deceleration.
6 •
It will close slowly to detect the force during deceleration.
7 •
It will open at normal speed until it reaches the opening limit switch.
8 •
It will close immediately, stopping only when it reaches the closing limit switch.
9 •
Programming completed.
EN
EN
