09.A
09.B
FUNCTIONS ◁
04
.
MC65 CONTROL BOARD
▷ FUNCTIONS
04
.
MC65 CONTROL BOARD
▷ Fim de curso automático para fase de subida/fecho
There is, in the control board, an limit-switch automatic system to use in the awning.
Whenever it is identified an excessive current absorption (by one motor) during
opening/closing, due to the possible presence of an obstacle or the complete movement
of opening/closing, the control board stops immediately the maneuver and relieves.
▷ Programming buttons and indicator LEDs
SEL key:
selects the type of function to be memorized, the choice is indicated by the
flashing of the LED. Pressing the button more times, it is possible to position yourself in
the desired function. The flashing LED indicates that the selection is active, but the
duration is 15 seconds. At the end of this period, the control board returns to its normal
status.
SET button:
makes the choosen programming with the SEL button.
LED signaling
LED on:
option saved.
LED off:
option not saved.
Intermittent LED:
option selected.
▷ Main menu
CODE
(Programming the remote control to operate the awning and the wireless Wind
Sensor)
CODE LAMP
(Programming the remote control to operate a lamp)
T.MOT
(Programming the Working Time/ motor)
▷ Programming the remote control 1 or 2 keys and Wireless Sensor
The programming of the transmission codes of the remote control is performed as
following: press the
SEL
button and CODE LED will blink. At the same time, send the
first code (closing) selected with the desired remote control. The LED CODE will flash
rapidly.
Send the second code (opening) to be memorized, the LED CODE will remain ON and
programmation is finished. If the second code is not sent within 10 seconds from the
first one, the unit exits the programming phase, leaving only a button on the remote
control to work step by step (open/stop/close).
▷ Programming sensor wireless (sun/wind/rain)
If you want to memorize a wireless sensor, follow these steps:
1º
Turn ON the power supply of the sensor;
2º
Open the memory of the control board MC65. For this step we have two options:
(option 1) - Open the control board as follows: use the SEL button to go to the LED
CODE. (option 2) - With the awning openned and lighting turned off, continually press
the remote’s opening channel memorized for more than 10 seconds until the light of
the awning flashes once;
After opening the control board’s memory, you have 10 seconds to send the sensor’s
order to the control board.
3º
(Sensor) Use the SEL button to go to the LED CODE (led starts to blink),
immediately press the SET button of the sensor so that it emits a rapid flashing of the
LED CODE until the light of the awning flashes once;
4º
With the SEL button of the sensor, you must now
select the functions you want to leave
activated in the sensor the sun/wind/rain.
Press SEL repeatedly until the LED of the
desired function flashes. With the LED
flashing, press the SET button for more than 1
second until it is fixed (LED turned on = active
function).
To disable any function, repeat point 4 but press the SET
button at least for 1 second and the LED goes out, leaving
the function disabled.
CODE
CODE LAMP.
No code
Ref. LED
LED OFF
LED ON
Programmed code
No code
Code of permanent light
programmed
Motor time programmed
Working Time - 3 min
T.MOT
