05.A
05.B
14
15
16
17
21
21
1
2
19
3
↑
↓
20
A
18
D
D
E
01
- To start the inclination arms regulation, fully open the awining. Assist the awning
indicated area during the whole regulation process (
E
).
02
- Loosen slightly the and screws as shown in the
image 19
.
1
2
04
- Tighten the screws and (
imagem 19
).
1
2
03
- Adjust the (
image 20
) screw until it reaches the desired inclination. Rotating
clockwise the awning up , rotating to the left down . Make this operation in one
arm and only then in the other. Don’t loosen the two arms at the same time.
3
↑
↓
03
.
INSTALLATION
03
.
INSTALLATION
INCLINATION ARMS REGULATION ◁
▷ CEILING INSTALLATION
Insert the wall brackets (
nº8
)
in casing holders (
nº4
) and
measure it (
A
) with the
supports. Transport this
measure (
A
) to the ceiling
where it will fixed.
From here, follow all the steps
used in the wall installation
(
page 03.B
) using, in this case,
the brackets (
nº21
) for the safe
fixation in the area
B
of the
image 1
.
Make the fixation on the consoles (
nº21
) using one of the two options identified in the
images
14
and
15
(use
M12
screws with washers).
Console (
nº21
) to be applied in zone
В
of image 1 (
page 03.A
).
OPTION 1
OPTION 2
RELIEVE 1 ARM EACH TIME
Area of assistance during joint regulation.
Area of assistance during the inclination arms regulation.
