© Motor City Wash Works, Inc. 48285 Frank, Wixom Michigan 48393 U.S.A.
Phone: 248.313.0272 ▪ Fax: 248. 313.0271
8MANULTOPWHL0001 12-9-20
www.motorcitywashworks.com
26
Maintenance:
DAILY:
Check for hydraulic leaks, chaffed hoses electrical cable, etc.
Visually inspect for any sign of wear.
Move the arms manually and duplicate its regular motion and look for abnormalities: A loose fastener may
allow some parts to move or rub and may create a dark stain running down the equipment.
Inspect belts for wear and/cuts or cracks and replace as needed.
WARNING
!
IMMEDIATELY REPLACE ANY BELT SHOWING
ABNORMALITIES SUCH AS: WEAR MARKS, CRACKS, RUST, OR CUTS.
THESE MAY HAVE BEEN CAUSED BY A MISADJUSTMENT OF THE
SAFETY BELT (DOUBLE BELT) OR BY CHEMICALS USED IN YOUR
WASH PROCESS. THIS WILL AFFECT THE INTEGRITY
OF THE BELT CASING OVER A PERIOD OF TIME.
Start the day with a TEST WASH and check for proper operation.
While you are watching the TEST WASH, check for clogged nozzles. If a nozzle is clogged, remove the
nozzle body and clean the nozzle by inserting a small piece of wire (a small paper clip wire will be fine!) in
the nozzle opening.
Check also for proper coverage of the Streamer™ Foamer.
Check for the overall performance of the equipment on the vehicle: profiling, cleaning, etc..
Wash down your equipment and the area around at the end of each day.
MONTHLY:
Each piece of MCWW equipment is assembled with the highest quality bearings and has been factory pre-
lubricated, therefore, they do not require supplemental grease for the first month of operation.
Use a lithium-based NLGI #2 grease (ex: Exxon Mobil MOBILITH AW2).
WARNING
!
OVERLUBRICATION IS A MAJOR CAUSE OF BEARING FAILURES!
LUBRICATE CONSERVATIVELY!
After the first month of operation, grease each bearing (see Picture #40 and 41).
Wash your equipment with a solution made of a mild degreaser and water. Rinse thoroughly.
Perform daily maintenance.
