Motomaster Eliminator, Руководство пользователя

Страница: 13 / 48

13
JUMP ST
AR
TING
model no. 011-1906-4 contact us 1.888.942.6686
3.) When disconnecting, disconnect in the reverse
sequence, removing the negative first (or positive first for
positive ground systems).
•Jump Starting:
1.) Verify the voltage and chemistry of the battery.
2.) Confirm the battery clamps are connected to the
correct polarity battery terminals.
3.) Connect the clamps to the jump starter.
4.) Make sure all of the vehicle’s power loads (headlights,
radio, air conditioning, etc.) are turned off before
attempting to jump start the vehicle.
5.) Press the Power Button to begin jump starting. All
LEDs will flash, indicating that all LEDs are properly
functioning. If you are properly connected to the battery,
the White LED will illuminate. If the battery clamps are
connected in reverse, the Red Error LED will illuminate.
Reverse the connections to clear this error and then the
White LED will illuminate. The White LED is illuminated
when the jump starter is ready to jump start your vehicle.
6.) Try starting the vehicle. Most vehicles will immediately
start. Some vehicles may require the jump starter to
be connected for up to 30 seconds before starting.
If the vehicle does not start right away, wait 20-30
seconds and try again. Do not attempt more than five
(5) consecutive jump starts within a fifteen (15) minute
period. Allow the jump starter to rest for fifteen (15)
minutes before attempting to jump start the vehicle again.
7.) Once you have started your vehicle, disconnect the
battery clamps, and remove the jump starter.