Page 21
M3 PRO - Distance Readouts
Distance Readouts
There are three different distance readouts – “Drive”, “Round” and “Lifetime”. You can toggle through them at any time by
pressing the left button. To reset the reading, press the right button (this must be done whilst the display shows “Drive” or
“Round”). To get an accurate reading turn on your trolley and walk directly to your golf ball. We appreciate that you will not
always be able to walk directly to your golf ball - however when you can it’s great fun to see how far you’ve hit it. You can
change the distance readings from yards to metres (or vice versa) by pressing and holding the left button for 3 seconds.
Please note the trolley will only measure distance whilst it is switched on and the motor is running (i.e. if you push the trolley
along when it is switched off the distance readings will not increase). The measurements are taken from the revolutions of
the axle, so please be aware that if you let your trolley run off down a hill on its own the readings will not be 100% accurate.
We recommend you always walk within a few steps of your trolley and do not let it run off ahead of you.
The “Lifetime” reading cannot be reset, even if you unplug the battery. This shows how far the trolley has travelled in its
lifetime. You can toggle to it by pressing the left button. This reading is displayed in miles or kilometres. Toggle between
miles or kilometres by holding down the left button for 3 seconds.
