Operation and Maintenance Manual for PowerKit 6M16 Series
3 of 40
Notice
1.
Before delivery, this series of diesel engines have already been tested, strictly following the test
specification. Therefore, never dismantle the lead sealing on the throttle to raise its openness.
Never dismantle or impact the rotor of turbocharger which belongs to the sophisticated parts;
never loosen or remove the main bearings of diesel engine and bolts attached to connecting rod
which have strict requirements for torque and angles.
2.
As the bolts attached to connecting rod are disposable, never reuse them.
3.
The operator of diesel engine should carefully read this Operation and Maintenance Manual, be
familiar with the structure of the diesel engines and closely abide by the technical operation and
maintenance procedures specified in this manual.
4.
At any time of starting the diesel engine, please check whether the coolant and engine oil is
filled up.
5.
For the new diesel engine, 50h running-in is needed, with maximum load not more than 80% of
the rated load and average load not more than 60%.
6.
The starting time of the engine should not last for more than 30s. If the engine can’t be started
within 30s, wait for 1-2min for startup again.
7.
After the diesel engine is cold started, please slowly increase the rotating speed, do not make
high-speed operation suddenly and never idle running for long time.
8.
After engine running with heavy load, do not immediately stop it. It is necessary to idle
running for 5-10 min at low speed.
9.
After engine is stopped, if the ambient temperature is less than 0
℃
, moreover additive is not
applied; please completely drain the water in radiator and diesel engine.
10.
The diesel engine is prohibited to work without air filter which could prevent particulates from
entering the cylinder Please select the specified fuel and oil grades which will be filled into the
diesel engine (it is suggested to use the Baudouin special oil sold at all service stations of
Baudouin when change the lubricating oil). Use the special clean container.
11.
The fuel and oil should be filtrated through the strainer before added. Let the fuel precipitate for
72h or more.
12.
Do not simultaneously use the diethyl-ether-assisted starting equipment and pre-heater or glow
plug.
13.
The inspection of electrical system should be done by the personnel mastering electrical
knowledge.
14.
The invalid duration of oil sealing of diesel engine is one year. If they expire, please take
necessary supplement measures.
15.
Our company perform the quality-trace filing for industrial power 6M16.
