27
Note: Calibration has been performed in the factory.
Controller calibration should not be necessary. Calibration
should be undertaken only by trained personnel.
(1) Set the Controller switches
SWA
,
SWB
, and
SWC
to
0
and set trim in center.
(2) Set the
SWB
switch at
1
, the
SWA
and
SWC
switches at
0, push up the forward/backward trimming and turn ON the
power switch at the same time. When three indicators on
the Controller are all lit, Controller Calibration mode has
been entered.
(3) Rotate the throttle stick and forward/backward stick in
2-3 circles and then place in the middle.
(4) Rotate
AUX 1
and
AUX2
rotary controls to the left and
right and then set at “0”,
(5) Set the
SWB
switch to
0
. The calibration will be finished.
CONTROLLER CALIBRATION
ON
ON
ON
Put “SWB” mode switch to “1”
Put “SWB” mode switch to “0”
Put throtte in the middle (50%)
and hold the trimming upward
Push the two control sticks of the transmitter
to rotate in any direction with the largest
distance (as Figure2). After repeating two
circles, put the throttle to the middle (50%)
