25
Interface
Power: The red end is positive and the black end is negative.
The input voltage is 10V—16V (we suggest you to use a
3S LiPo). Please use BEC if the voltage of power/battery
exceeds the above value. The gimbal can support a general
receiver and it can access the proportion knob channel to
perform gimbal pitching and rolling.
Y1: The gimbal pitching axis controls the input channel.
When not being operated manually, the gimbal pitching axis
will maintain a horizontal position.
Insert to S3 interface (as shown).
Y2:The gimbal rolling axis controls the input channel. When
being controlled, the gimbal rolling axis will maintain a
horizontal position.
Insert to S4 interface (as shown).
USB
The USB of the gimbal can be used for gimbal parameter
adjustment and firmware upgrades.
Reset button: Use only to force-enter Firmware Upgrade
mode. When there are problems in the normal upgrade
process and gimbal does not function normally, turn OFF
the power and press the button again, simultaneously
powering on the gimbal; it will enter Firmware Upgrade
mode to upgrade the firmware (as shown).
GIMBAL
Reset
Reset key
S3 +5V G
S4 +5V G
Sensor Calibration
When an extended time has passed since the most recent
use or power on, one axis of the gimbal will slope to
one side slowly. In this event, calibration of the sensor
is necessary. You can use the software of Hohem 2-Axis
Brushless Gimbal to make calibration. Please make
the operation strictly according to the directions of the
software. Otherwise, the gimbal may not work normally.
Note: Before delivery, the gimbal has already been
calibrated. Please do not calibrate it if unnecessary.
