Mosa MS 200 S, Руководство по эксплуатации и обслуживанию

Страница: 12 / 48

USE AS A WELDER MSG 200 - MSG CHOPPER
© MOSA 1.0-03/98
02/03/92 22220M6.1 - GB
M
6.1
Insert the electrode cable plug into the (+) socket and the work cable plug to the (-) socket and tum them clockwise until they are
tight.
The machine is ready for welding.
Cables should not exceed a length of 16 feet (5 m) and should be AWG3 (25 mmq) or larger.
The use of other cables (smaller section and larger) will reduce the output of the welder.
Start the engine and set the welding current adjusting lever (12) to the desired welding current and the machine is ready for
welding.
The engine runs at idle until the electrode comes in contact with the workpiece.
Once contact has been made an electronic circuit automatically increases the engine speed to give the welding current
selected with the welding current adjusting lever.
When the electrode is removed from the workpiece the engine retums to idle.
To strike the welding arc scratch the electrode against the workpiece as if striking a match.
Do not hammer the electrode against the workpiece.
The welding current adjusting lever (12) gives minimum current when it is at the bottom and maximum current when it is at the
top.
The welding current can be adjusted while welding.