![background image](http://html1.mh-extra.com/html/mortara/quinton-cr60/quinton-cr60_user-manual_1836792052.webp)
RECEIVING AND INSTALLATION
44
Installation
If you choose to install your treadmill without the assistance of your representative, follow the procedure given
below:.
Tools
hex wrench (supplied in kit)
Phillips screwdriver (12-inch length preferable)
small flat-blade screwdriver
torque wrench if available
Procedure
1.
Grasp the controller uprights and rotate into position, as shown in the following figure.
Figure 8 Controller Uprights
2.
Align the holes in the base of the uprights with the holes in the upright brackets (previous figure). Fasten the
uprights into place with the hardware supplied with the treadmill: 5/16-18 x 7/8-in. hex bolt, 5/16-in. lock
washer, and 5/16 in. flat washer.
3.
Tighten each bolt securely with the 1/2-in. torque wrench. Tighten to 200 in/lb (22.6 Nm).
Do not overtighten.
4.
Remove the treadmill hood and hood cover from the two boxes. Position the hood on the treadmill deck and tilt
as shown in the following figure.
Содержание Quinton CR60
