12
SECTION 5
ELECTRICAL CONNECTIONS
A. NEUTRAL SAFETY SWITCH
The SL-3 Control is provided with a Neutral Safety Switch. This Switch is used to prevent the engine from starting in gear.
6.1 With the Control in NEUTRAL, connect one wire of the tester to
the common terminal, and one wire to the ‘NO” Normally Open)
Terminal The test light MUST light.
6.2 Connect the Neutral Safety Switch between the ignition switch
(start lead) and the starter solenoid (see diagram).
CHECK TO MAKE SURE THAT THERE IS
ELECTRICAL CONTINUITY ONLY WHEN
THE CONTROL IS IN NEUTRAL. WHEN
THE CONTROL IS IN GEAR THERE MUST
NOT BE ANY ELECTRICAL CONTINUITY.
USE A BATTERY-POWERED TEST LIGHT OR TEST METER TO CHECK CONTINUITY.
FIGURE 9 - NEUTRAL SAFETY SWITCH
CONNECTIONS
CAUTION
NOTE
