5
Morrison Bros. Co. ‑ Dubuque, IA ‑ 800‑553‑4840
1218CT0112 PP rev 04‑14‑2022
Wiring Steps
Note:
For steps 1-12 please refer to the Power
Converter Module wiring diagram shown in
Figure 3.
1. On the 1218C Console’s interface board,
locate the board’s input power connecter and
disconnect the mains line/hot wire (black)
from the left-most position of the connector.
2. Strip the mains line/hot wire 11mm (1/2 inch)
if not already stripped sufficiently. Use the
Wago 3-position connector included in the kit
as reference, shown in Figure 4.
3. Flip the first lever open on the Wago
3-position connector and insert the mains
line/hot wire into the connector and close the
lever, ensuring the wire is secured properly.
4. Locate the two black wires that were included
in the kit and strip one end of the 4-inch
wire approximately 11mm (1/2 inch). Flip
the second lever open, insert the stripped
wire into the connecter, then close the lever
ensuring the wire is secured properly.
5. Strip approximately 5mm (1/4 inch) off the other end of the 4-inch black wire and connect it to the line/hot pin on
board’s input power connector, the left-most position.
6. Next, strip the 8-inch wire approximately 11mm (1/2 inch). Flip the third lever open, insert the stripped wire into
the connecter, then close the lever ensuring the wire is secured
properly.
7. Back at the 1218C board’s input power connector, disconnect the
mains neutral wire (white) from the middle position.
8. Strip the mains neutral wire 11mm (1/2 inch) if not already
stripped sufficiently.
9. Locate the second Wago connector and flip the first lever open.
Insert the mains neutral wire into the connector and close the
lever, ensuring the wire is secured properly.
10. Locate the two white wires that were included in the kit and strip
one end of the 4-inch wire approximately 11mm (1/2 inch). Flip
the second lever open, insert the stripped wire into the connecter,
then close the lever ensuring the wire is secured properly.
11. Next, strip the 8-inch white wire approximately 11mm (1/2 inch). Flip the third lever open, insert the stripped
wire into the connecter, then close the lever ensuring the wire is secured properly.
12. Strip 5mm (1/4 inch) off both of the remaining 8-inch wires that are secured in the Wago connector.
Figure 3: Power Converter Module Wiring Diagram
Figure 4: 5mm (approximately ¼ inch) stripped and 1218C input power connector connection.
Figure 5: 5mm (approximately ¼ inch)
stripped and 1218C input power connector
connection.
