Morris CX 8105, Руководство оператора

Страница: 61 / 182

Operation
CX 8105 - Ground Drive December 2016 5-27
Seeding Fine Seeds (Canola, Mustard, etc.)
When seeding fine seeds such as canola or mustard, the
slow speed transmission has to be engaged to ensure
the low rates required for these products.
The slow speed transmission is incorporated in
All the
Posi-Drive Transmissions.
• To engage the slow speed, remove the large hairpin
from the front shaft and install through the sleeve and
shaft located at the rear of the transmission.
Note: Shaft will have to be rotated to align holes for
pin insertion.
• To disengage the slow speed, reverse the above
procedure.
• Rate checks can be performed the same way as for
other seeds.
• Usually it is necessary to reduce the fan rpm when
seeding fine seeds. See “Fan Speed” for specific fan
speeds.
Applying Inoculant
When inoculant is applied at the time of seeding, once
the air cart has been filled, the fill-lids should be left
open and the fan run for 5-10 minutes at full rpm to dry
the seed.
Calibration must be done after the seed is dried,
otherwise the calibration will be incorrect.
Note: If the seed is not dried then the seed will have
a tendency to bridge and not meter into the
air stream.
Rear Transmission Shown
HAIRPIN
N19028 - Slow Speed