Morris CX 8105, Руководство оператора

Страница: 102 / 182

Monitor
6-16 December 2016 CX 8105 - Ground Drive
Monitor Settings - Continued
See charts on following pages for
monitor settings.
Changing Monitor Settings
The following example explains the procedure for
changing settings.
Entering the “Settings Menu”
Example: Change the implement width to 41.5 ft.
1. From the “Operating Screen” press the MENU key
to enter the “Settings Menu”.
Use the Up/Down keys to select the desired function.
Press the soft key below SELECT to enter the
function “Implement Setup”.
2. Under each function there is a list of parameters that
can be changed, see “Settings Menu” chart.
3. Use the Up/Down keys to select the parameter.
“Implement Width”.
4. Press the SELECT key to highlight the value. Use
the Up/Down keys to change the value to “41.5 Ft”.
5. Press the soft key below SELECT to enter the value
and move to the next parameter in the list.
Set all parameters in the list as indicated in the above
steps.
6. When all parameters in the list have been set, use
the Up/Down keys to highlight “Exit and Save” press
the SELECT key to save the changes and return to
“Settings Menu”.
Proceed to set all function parameters as indicated
in “Settings Menu” chart.
Saved settings are retained even after power has been
removed from the monitor.
Note: When the operator is in any of the “Settings
Menu” modes, the monitor will not generate
normal monitor alarms (i.e. low fan speed,
shaft speed and so on).
1
2
3
4
5
6