Morris CX 8105, Руководство оператора

Страница: 103 / 182

Monitor
CX 8105 - Ground Drive December 2016 6-17
Important
Select “Exit and Save” in
each Menu Setting to save
changes.
Settings Menu Chart - Standard Drive
Installation
Install New System __________ See “Sensor Installation”
Replace a Sensor ___________ See “Sensor Replacement”
Add a Sensor ______________ See “Sensor Replacement”
Remove a Sensor ___________ See “Sensor Replacement”
Implement Setup
Units _____________________ Select Imperial or Metric
Implement Width ____________ Set to width of seeding tool
Clear Field Area ____________ See “Resetting Area”
Clear Total Area ____________ See “Resetting Area”
Speed Settings
Pulses Per Rev _____________ Set to 4
Wheel Pulses Per 400 Feet ___ See PP400 Chart
Speed Calibration ___________ See “Pulse Counting Mode for PP 400”
Fan Settings
Pulses Per Rev _____________ Set to 2
Low Alarm Point ____________ Set to 3000 rpm
High Alarm Point ____________ Set to 5000 rpm
Bin Settings
Tank 1, Tank 2 and Tank 3
Alarm Setting ______________ Enabled (default) Set to Disabled if tank is not in use.
Shaft Settings
Shaft 1, Shaft 2 and Shaft 3
Settings ___________________ Pulses Per Rev Set to 4
Low Alarm Point 2.0 rpm
- Can be adjusted to 0.5 rpm for low rates.
Blockage Module Settings
Runs per Module Setup ______ Set individual Module number of Runs
Individual Runs Setup ________ Allows Runs to be Enabled/Disabled
Blockage Module Test ________ See “Blockage Module Test”
Blockage Calibration _________ See “Blockage Calibration”
Global Settings
Language _________________ Select English or Russian
Volume/Pitch _______________ 50% (default)
Set as desired.
Backlight __________________ 50% (default) Set as desired.
Contrast __________________ 100% (default) Set as desired.
Restore Default Settings ______ Resets ALL Monitor Settings to defaults
Note: Only setting parameters that are relevant are displayed (i.e. if no Shaft 3 is installed, there will not be
any Shaft 3 setting parameters made available).