8
Features
Dry ironing:
To use your ATOMiST vapour iron as a dry iron only,
follow steps 3, 4 and 6 of ‘Quick Start Guide’ on page
3. You do not need to put water in the tank
(6)
.
Auto shut-off:
If the ATOMiST vapour iron is not used for 10 minutes,
the product will automatically enter standby mode,
both for safety and to save energy.
Wake the product by pressing either the precision
temperature control
(4)
or the precision vapour mist
trigger which will illuminate the power light
(11)
. The
previous temperature setting will be restored.
Please wait until the temperature indicator lights
(15)
stop flashing before resuming ironing.
Emptying and
storing
When you have finished Ironing, press and hold the
precision temperature control
(4)
for three seconds to
switch the ATOMiST vapour iron into standby.
Unplug and empty all water from the water tank and
place the iron on the base
(14)
. Use the power cable
storage hole
(10)
to keep the power cable
(9)
tidy.
NOTE: Do not store the vapour mist cord
(12)
in the
power cable storage
(10)
, this is for the storage of the
power cable
(9)
only.
Maintenance
To clean the Thermoglass soleplate:
Wait until cold and use a damp cloth and mild
detergent to wipe over, then wipe dry. Do not spray
detergent directly onto the soleplate.
To remove fibres from the Thermoglass
soleplate:
If any man-made fibres fuse to the Thermoglass
soleplate
(3)
, set the iron to the 3-dot or MAX position
and pass it over a clean piece of cotton to draw the
deposit off the surface.
To clean the exterior:
Allow the unit to cool and wipe over with a damp cloth
and mild detergent, then wipe dry.
