8
When not in use, the attachments may be stored
on the charging cradle base
(20)
. Assemble the
dusting brush
(3)
onto the upholstery nozzle
(2)
and push them onto the crevice tool
(1)
. Then
push this assembly onto the accessory holder
(16)
on the charging cradle
(15)
.
Empty the dust canister
(13)
regularly even if it
does not look full, this will maintain the
performance.
1.
Remove the handheld vacuum cleaner
(12)
from
the main vacuum cleaner body
(7)
(see ‘Handheld
vacuum cleaning’, page 7).
2.
Press the dust canister release button
(11)
and
pull the dust canister away from the handheld
vacuum cleaner.
3.
Remove the dust canister filter
(14)
and empty the
dirt from inside the dust canister.
4.
If the filter
(14)
is not washed as instructed in
‘Maintenance - filter’, it is recommended that the
filter is brushed or tapped clean before refitting
on each empty of the dust canister.
5.
Replace the filter into the dust canister
(13)
, then
replace the dust canister back onto the handheld
vacuum cleaner.
6.
Replace the handheld vacuum cleaner
(12)
back
into the main vacuum cleaner body
(7)
if upright
cleaning.
WARNING: Always remove the handheld vacuum
cleaner from the main vacuum cleaner body and
the charger from the mains supply before
undertaking any maintenance or cleaning
procedures.
Your cleaner is manufactured to withstand normal
day-to-day use, but an occasional wipe over with
a damp cloth will help maintain its good looks.
Take care not to get the electrical connections wet.
Abrasive cleaners should not be used.
The guarantee may be invalidated if the motor is
damaged due to: using the appliance without
the filter installed; not cleaning the filter; or not
replacing a damaged filter.
Cleaning the dust canister filter
To maintain suction, the dust canister filter must
be cleaned each time the dust canister
(13)
is
emptied.
1.
Follow steps 1-4 of ‘Emptying the dust canister’.
2.
Pull the filter out from the filter assembly
(14)
.
Also, open the lid to the cyclone cone and clean
the cyclone.
3.
Every month, wash the filter in luke-warm water
and thoroughly air dry before re-fitting.
IMPORTANT: Do not wash filters with hot water
or detergents.
Emptying the dust canister
Tool storage
Maintenance - filter
Maintenance
VC732000MUK Rev1_Instruction Book 13/12/2013 14:57 Page 8
