SETTING THE BATCH QUANTITY
PRESS THE
MODE
SWITCH UNTIL THE
BATCH
LAMP IS ON. ROTATE THE VALUE DIAL TO
DETERMINE THE BATCH SIZE.
RUNNING THE MACHIHE
ONCE ALL OF THE PREVIOUS SETTINGS HAVE BEEN ADJUSTED THE MACHINE IS READY
TO START FOLDING. WHILST THE MACHINE IS IN OPERATION, THE DISPLAY CAN
EITHER SHOW THE
RATE
AT WHICH THE SHEETS ARE BEING FOLDED (SHEETS PER
HOUR) OR SHOW THE
TOTAL
AMOUNT OF FOLDED DOCUMENTS. THE DIAGRAM BELOW
SHOWS THE DISPLAY WITH THE MACHINE OPERATING IN THE
RATE
MODE. TO CHANGE
BETWEEN MODES, OPERATE THE MODE SWITCH UNTIL EITHER THE TOTAL OR RATE LAMP
IN ON.
PRESS THE
RUN
SWITCH, THIS WILL START BOTH DRIVE MOTORS. THE SPEEDS OF
BOTH MOTORS CAN BE ADJUSTED INDEPENDENTLY AT ANYTIME DURING THE MACHINES
OPERATION. NOTICE THE
MOTORS
LAMP WILL NOW COME ON.
PRESS THE
AIR
BUTTON TO
ON
, THIS WILL START THE COMPRESSOR. NOTICE THE
VACUUM
LAMP WILL NOW COME ON.
PRESS THE SAMPLE SWITCH TO FEED A SINGLE SHEET IN ORDER TO EXAMINE THE
FOLD. IF THE OPERATOR IS SATISFIED WITH THE RESULT, THE
FEED
SWITCH CAN
THEN BE OPERATED.
THE DISPLAY IN
RATE
MODE,
THE DISPLAY IN
TOTAL
COUNT MODE
11
