R O T A R Y
PAGE 32
If your machine is fitted with Heads from a different manufacturer
or you are unhappy about dismantling them please use the
instructions supplied with your heads or consult your dealer.
Repeat or skip numbering is achieved by replacing the standard
unit wheel with a special wheel.
Using a 1/16” Allen key, release and unscrew ‘A’ five full turns. the
action lever ‘B’ may now be worked loose and removed from the
head.
Release and unscrew ‘C’ three full turns, and using a drift
‘D’ (available as an option under part number 41-001-3) push the
centre shaft so that it is protruding 16mm ( 5/8” ) out from the other
end of the Head.
The drift may now be withdrawn and the unit wheel lifted clear of
the Head.(see Fig 10.52)
NOTE ...... As you remove the unit wheel, be sure you have a finger
over the lower part of the retaining pawl otherwise the
tiny spring behind will be lost.
Numbering Wheel Removal....................................... Fig 10.52
Section 10
MAINTENANCE
