Page 8
FOLDING
ADJUSTING THE TILT OF THE FEED BED
FITTING THE TRANSFER BED ASSEMBLY TO THE AUTOCREASER AND
ALIGNING THE MACHINES.
1. The Feed Bed can be tilted, so that it matches the height of the creasing unit that is
being used with it.
(i) Open the front and rear column covers.
(ii) Loosen the knurled locking collar at the top of the front gas spring.
(iii) Adjust the tilt of the Feed Bed, (up or down) to match the height of the creasing
unit, then re-tighten both of the knurled locking collars.
1. The AutoFold is supplied, as standard, with a Transfer Bed Assembly that fits onto the
AutoCreaser 33 and AutoCreaser Pro 33 machines. A Transfer Bed Assembly that will
fit the wider AutoCreaser 50 and AutoCreaser Pro 50 machines can be purchased as
an optional extra (see accessories and options on page 37).
(i) Remove the stacker unit from the AutoCreaser and fit the Transfer Bed Assembly as
shown in FIG.8
(ii) Tilt the feed bed of the AutoFold, as described above, to align with the Transfer Bed
Assembly as shown in FIG.8
Knurled Locking Collar
Front Column Cover
Rear Column Cover
Operating the AutoFold Pro
