Page 19
SYSTEM
SET BY POSITION
IMPORTANT NOTES
1. The best fold squareness is achieved when the fold is
on the center line of the
crease. It should be to one side of the crease center line as shown below.
Example. Half fold on 420 mm sheet
Set crease at 210.0 mm
Set fold at 210.5 mm or 209.5 mm depending on the desired finish.
2.
When using
all dimensions are from the leading edge of the
paper as shown in the example on page 20.
not
l
l
Set By Position,
Paper Type - 0, 1, 2 and 3, is a fold compensation for variations in
paper thickness, hardness and substrate. (see page 11)
SET BY FOLD
l
l
Paper type
‘0’
Paper type ‘1’ ‘2’
‘3’
- The crease and fold are set at exactly the same position. This may
be used but beware some thin stocks will allow the fold to wander from one side of
the crease to the other.
and
will move the fold relative to the crease and
should be tried out with the stock in use.
Generally a higher number will be best for a thicker stock, but some settings will
swap the fold from one side to the other side of the crease, this enables the user to
choose the side that the crease will be seen. For example, on a front cover.
center line of crease
ideal fold line
ideal fold line
AutoFold Pro
Operating the AutoFold Pro
