Recommended weekly operator maintenance
Technician Maintenance
Clean all sensors.
Clean in feed rollers and using the cleaning kit supplied (cleaning kit part number 90-018).
It is recommended that your Machine is fully serviced at least once every six months by a factory
trained Service Engineer.
The lead edge sensor housing is located on the layedge side of the machine between the input
roller shafts. With a slim brush the sensors can be cleaned when required. Pass the brush under
the ball holder and push through until it passes the infeed rollers. Alternatively it can be blown
with compressed air.
The Jam Sensor is situated just after the edge sensor and is inline across the paper path
with the receiver in the operator side sideplate. This is not usualy sensitive to dust but if required
can be blown with compressed air.
Clip 1 sensor is situated on the lower guides beneath the delivery conveyor and can be
cleaned when required using a slim brush.
Clip 2 sensor is situated on the upper guides inside the top cover and can be cleaned
when required using a slim brush.
Page 35
SYSTEM
Trouble Shooting
Error Screens (Continued)
Sheets too close
Overlap
If the machine stops and error message 13 is displayed on the touch screen, this
indicates that the ‘Lead Edge Sensor’ has seen a sheet subsequent to the first
one as being longer. Again this could actually be a longer sheet, OR it could be a
sensor problem (if it is a recurring problem). Check that the paper gate has been set
correctly.
If the machine stops and error message 45 is displayed on the touch screen, this
indicates that the sheets are too close together. The rate of feed of the sheets needs
to be slowed down. If the sheets are being fed from an AutoCreaser Pro 33 or an
AutoCreaser Pro 50 adjust the speed on the Tools Menu screen to a slower speed.
AutoFold Pro
