4
MORDAX : DATA
User Guide
SYS V. 01.00.00
BOOT V. 01.00.00
Updated: 161229
When the DATA starts up you are brought to the Main Menu. Use the
encoder knob to scroll through the menu; when you have highlighted the
program you wish to use, push in on the encoder to launch the program.
You can also access the system’s Settings page from the Main Menu by
pushing soft-button 1-4, located under the screen text ‘SETTINGS’.
The function of the DATA’s buttons and encoder, as well as the DATA’s
input and output jacks, are specific to each program, and are covered in
each program’s section of this manual. Generally though, the user input
controls have the following common behaviors throughout the system:
1. In Wave Output, push soft-button 2-3,
corisponding to the CV item at the top of the
display, to engage the CV pop-up menu.
3. Push the encoder to act on this parameter.
Turn the encoder so the parameter is NONE.
Push the encoder again and scroll to move to a
different parameter.
4. When you’re done with the CV
assignments, hit soft-button 2-3 again to
leave the pop-up menu.
2. Turn the encoder to select WAVE1 CV source
for DVCA, as indicated by the hollow green box.
Currently CV INPUT 2 is the active source.
Getting Around the DATA System
Navigation Example: Change WAVE1 CV DVCA Assignment
• Boxes with text along the display top and bottom correspond to
the soft-buttons along that edge. These boxes can allow the ability
to select pages in a program (e.g., Settings), activate a pop-up
menu (e.g., Scope cursor sub-menu), or engage a control (e.g., Volt
Monitor CV control).
• The encoder is used to scroll available items in a list or menu.
Often in pop-up menus pushing the encoder will select that item,
then turning the encoder will act on that variable. Pushing the
encoder again will return it to scrolling the list.
