Mopedia RS810, Инструкция по эксплуатации

Страница: 18 / 36

6
ENGLISH
9. BEFORE USE
• Check if the frame is damaged in order to guarantee a safe use for people and things
• Check the correct assembly of the device
10. CAUTIONS FOR USE
The manufacturer and distributor are not responsible for any responsibility for the
consequences of improper use of the product.
• Always help the patient with walking difficulties to position themselves on the seat
• Do not use with patients who exceed the maximum weight shown on the label placed on
the product frame
• Avoid sudden movements during positioning
• Be careful on wet floors, on wet or slippery surfaces, it could make difficult the patient
positioning
• Do not store the product outside. Periodically check the stability of the product and the
correct fastening screws and the status of protections rubber
• In case of doubt for the use, the adjustment or the maintenance of the product, please
contact your dealer
Do not exceed the maximum load capacity for any reason!
11. HOW TO USE
11.1 RS810
• Place the seat in the tub and tighten the stoppers to make it stable
• Place the handle on the side opposite to the point of access to the tub
• If necessary help the patient to position on the seat
• Use the handle as an aid to move and position themselves correctly in the seat
11.2 RS815
Position the seat and open it on a smooth flat surface. Check the stability of the seat before use.
11.3 RS817
Height adjustment
Press the pin to adjust the seat by removing the pole and putting it into the holes to the
desired height and the maneuverability of the patient. Return the stop in the hole to lock it.
Check that all four legs are of the same height.
Place seat on a flat, level surface. Check the stability of the seat before use
12. CLEANING AND DISINFECTION
12.1 Cleaning
To clean the aid and the structure use a solution of alcohol and neutral soap (in equal parts)
mixed with water. Do not use abrasive substances, acids, alcohol, chlorine-based cleaners,
disinfectants and acetone when cleaning, because these substances cause the abrasion of the
plastic surfaces and rusting of metal surfaces.
The manufacture company cannot be held responsible for the damage that is caused by using
materials that could damage the product surface or corrosive chemicals during cleaning.
12.2 Disinfection
If you need to disinfect the product use a common disinfectant neutral detergent.