Mopedia RS810, Инструкция по эксплуатации

Страница: 17 / 36

5
ENGLISH
8. ASSEMBLING
8.1 RS810
The product is supplied unassembled and it is easy to assemble without the use of any tools.
Is composed by:
- Seat (1 pc)
- Stoppers (4 pcs)
- Handle (1 pc)
- Screws
Screw the four large plastic screws on the underside of the seat. Tighten them well with a
screwdriver or a small coin. To assemble the handle, position the seat with the stoppers facing
downwards, introduce the handle into the holes at the ends of the seat. The handle should
face the center of the seat. (Fig.1)
(Fig.1) (Fig.2)
Seat adjustment
(Only purpose picture)
• Turn the seat, loosen the 4 screws so that they can move
• Slide the 4 screws into the center of the seat centre so that they can easily adapt to the bathtub
• Turn to the seat again so you place in the tub with the handle facing the wall.
(The handle must always be on the side of the wall)
• Place the bath seat in the best position.
• Slide the cleats so that they touch the inside of the tub and tighten the thumbscrews
• Flip back the seat so that the cleats are facing upwards and adjust outward to about
2 mm on each cleat. Now tighten the brackets so that they do not move easily.
• Turn the hot seat from the right and press down gently in the bathroom (not force). If the
seat slides along the tub, you may need to adjust the supports further outward. To do this,
repeat steps from 2 to 7
8.2 RS815
The product is supplied assembled.
8.3 RS817
The product is supplied unassembled and it is easy to assemble. In the package you will find:
- Round seat with frame (1 pcs)
- Legs (4pcs)