6
39. Engage the air inlet hose to the resonator and install
the air cleaner body (1) with two bolts (2) tightened to
9 N∙m (80 in. lbs.).
40. Tighten the air inlet hose to resonator clamp (5) to 4
N∙m (35 in. lbs.).
41. Install the push pin (3).
42. Install the fresh air makeup hose (4) to the air cleaner
body.
43. Install the engine cover.
44. Raise and support the vehicle.
45. Check condition of all pulleys.
CAUTION: When installing the serpentine accessory
drive belt, the belt MUST be routed correctly. If not,
the engine may overheat due to the water pump rotat
ing in the wrong direction.
46. Install new belt (7). Route the belt around all pulleys
except the idler pulley (2). Rotate the tensioner arm
(8) until it contacts its stop position. Route the belt (7)
around the idler (2) and slowly let the tensioner (8) ro
tate into the belt. Make sure the belt (7) is seated onto
all pulleys.
47. Install the inner splash shield.
48. Install the wheel.
49. Lower vehicle.
50. Connect the negative battery.
Mar 18, 2011
K6861276
