Manual Part No: 931545-02 MV1 Gas Solid Top Range
- 26 –
Manual Rev No: 1
Service and Maintenance (cont.)
6)
To Remove a Hotplate Burner.
Remove the control knobs and control panel, which is secured by two fixing screws.
Remove the solid top sections, together with the gas tap cover plate (secured by four screws).
Undo the burner supply pipe by unscrewing the union nut at the injector elbow assembly.
Undo the three nuts and screws from the front of the burner and withdraw together with the
injector elbow.
Unscrew the injector elbow assembly.
Replace by reversing the above procedure.
7)
Converting NG Appliances to LP Gas.
Remove the control knobs and control panel, which is secured by two fixing screws.
Remove the solid top sections, together with the gas tap cover plate (secured by four screws).
Remove the hotplate burner injectors as described in Section 4 and fit replacement injectors
Hot
Plate
Burner 1.6mm
Injector
Part
No.924024-16
Working from the front of the appliance screw in fully both the thermostat and gas tap/FFD by-
pass screws.
From inside the oven remove the oven injector as described in Section 3 and fit replacement LP
injector.
Oven
Burner
1.7
mm
Injector Part
No.931455-08
Remove the gas governor from the inlet supply pipe.
Finally fit replacement Data Plate and re-test the appliance.
