Mooney M20TN S type, Руководство по эксплуатации для пилотов

Страница: 71 / 266

MOONEY
M20TN - MODEL TYPE-S
SECTION III
EMERGENCY PROCEDURES
3 -- 17
AIRPLANE FLIGHT MANUAL
ORIGINAL ISSUE -- 04-02-2008
OVERWEIGHT LANDING PROCEDURES
In the event it is necessary to land with weight exceeding 3200 Lbs. (1452 Kg.) (max. landing
weight) the following procedure is recommended in addition to normal APPROACH FOR LAND-
ING procedures:
Approach Airspeed 80 KIAS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Use a flatter approach angle than normal, with power as necessary until a smooth touchdown is
assured.
Expect landing distance over a 50 feet obstacle (Ref. SECTION V) to increase at least 600 ft.
Conduct Gear and Tire Servicing inspection as required (Ref. SECTION VIII).
SYSTEMS EMERGENCIES
PROPELLER OVERSPEED
Throttle RETARD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Oil Pressure CHECK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Propeller DECREASE RPM, re--set if any control available . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Airspeed REDUCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Throttle AS REQUIRED to maintain RPM below 2500 RPM . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Record POWER settings, MAX RPM, and duration TIME of overspeed event. . . . . . . . . . . . . .
NOTE:
Refer to Engine and Propeller operating manuals to determine continued airwor-
thiness requirements post--flight.
ALTERNATOR OVERVOLTAGE
(Alternator warning light illuminated steady and Alternator Field circuit breaker tripped.)
Alternator Field Circuit Breaker RESET . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
If circuit breaker will not reset, the following procedures are required:
1. Reduce electrical load, as required, to maintain essential systems.
2. Continue flight and LAND, when PRACTICABLE, to correct malfunction.
NOTE:
The only source of electrical power is from the selected battery. Monitor battery
voltage (min. 18V) and switch to other battery when necessary.
ALTERNATOR OUTPUT LOW
(Alternator annunciator warning light flashing)
Reduce electrical load.
If annunciator light still flashes:
Alternator Field Switch OFF . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. Reduce electrical load, as required, to maintain essential systems.
2. Continue flight and LAND, when PRACTICABLE, to correct malfunction.
NOTE:
The only source of electrical power is from the selected battery. Monitor battery
voltage (min. 18V) and switch to other battery when necessary.
Battery endurance will depend upon battery condition and electrical load on battery. If one bat-
tery becomes depleted, switch to other battery.