Moog ISA1 Series, Инструкция по эксплуатации

Страница: 6 / 16

Mounting ISA 1
6 Rev. -, April 2019
4.2 Mounting the sliding system drive
The sliding system drive may only be mounted in horizontal position.
Prerequisites:
• The mounting location is level and clean.
• The mounting location is suitable for the weight of the sliding system drive.
• Connection for power supply and to the signal transmitters is present at the mounting
location.
•
A suitable system for the transmission of the torque can be reached from the mounting
location via the pinion shaft (splined shaft) (e.g. the toothed pulley reaches the toothed
belt drive on the sliding system).
The sliding system drive can be fitted to the frame of the sliding system via threaded holes
in the base plate or via threaded holes in the gearbox flange (Fig. 4/1). The base plate has
2 threaded holes M5 with a maximum screw-in depth of 7 mm (Fig. 4/2) and 2 threaded
holes M5 with a maximum screw-in depth of 3 mm (Fig. 4/3).

Align the sliding system drive in the frame of the sliding system.

Drill the holes in accordance with the mounting drawing (Fig. 4).

Position the sliding system drive and fasten it with bolts.

Put drive element (e.g. toothed pulley) on the gear shaft and couple it to the drive
system (e.g. toothed belt).
Fig. 4 Mounting options
Do not use