Moog ISA1 Series, Инструкция по эксплуатации

Страница: 10 / 16

Commissioning ISA 1
10 Rev. -, April 2019
5 Commissioning
The following description applies for the commissioning both after first mounting and
after the installation of a replacement device.
5.1 Single connection
WARNING
Voltage.
While the housing is open, there is a risk of electrical shock.

Do not open the housing.

Do not put the sliding system drive into operation without housing.

Connect the communication cables from the operating element provided by the
customer to the connections I/O 1 (Fig. 9 /1) and I/O 2 (Fig. 9 /2).

Please contact Moog in the event that parameter values have to be set which deviate
from the standard values. For the standard parameter values refer to section 5.3.

Set address on the DIP switch to A1, and switches 5 + 6 to "ON".

Connect mains cable to mains connection (Fig. 9 /4) and connect with power supply.

Perform a teach-in run.
The RJ45 communication ports (Fig.
9/3, Fig. 9/5) are not assigned in the case of single
connection.
1 Connection I/O 1
2 Connection I/O 2
3 RJ45 communication port OUT
4 Mains connection
5 RJ45 communication port IN
Fig. 9 Single connection