Monzana 103556, Инструкция по эксплуатации

Страница: 9 / 17

16 17
www.DeubaXXL.de www.DeubaXXL.de
16
17
www.deubaxxl.de
www.deubaxxl.de
OPERATING INSTRUCTIONS
Safety
shield
Tool support
Tool support
adjustment knob
1. Loosen the hex head bolts located on the
inside of the wheel guard.
2.
and the hex head bolts securely.
NOTE: The distance between the support and the
grinding wheel should not be more than 1.5mm.
Installing the Safety Shields
Shield
support screw
1. Loosen the shield support screw.
2.
support. Place the shield support over the hole
and loosely screw in the shield support screw.
3.
Installing the Removing Grinding Wheels
Securing nut
Grinding wheel
Spindle
1.
that the power supply cord is disconnected
2. An 8mm Spanner, 19mm spanner and Phillips
the grinding wheels.
3. Remove the wheel guards, tool supports and
safety shields.
4.
in place.
5. While holding the spindle, using a 19mm
spanner loosen the securing nut.
6.
spindle of the grinder.
7. Clean all parts including the spindle of dirt and
other debris.
8.
hollow side is facing outwards towards the
grinding wheel.
9. Slide the new grinding wheel onto the spindle.
10.
rests against the grinding wheel. The hollow
side should face inwards towards the grinding
wheel.
11. Tighten the securing nut on the end of the
spindle.
NOTE:
This could cause damage to the grinding
wheel.
12. Install the wheel guards, tool supports and
safety shields.
13. Run the bench grinder for approximately one
minute before commencing work. Should
NOTE:
hand side of the bench grinder is operated with a
IMPORTANT:
complete stop before removing any material,
making any adjustments or changing grinding
wheels.
Grinding
1.
the work area.
2. Do not use cracked or damage grinding
immediately.
3. Always use the front of the grinding wheel. Do
not use the sides.
4. When grinding be careful to use the whole
face of the grinding wheel. By using only one
5.
the grinding wheel. Ensure control of the
workpiece and ease it gently onto the wheel.
6. When sharpening tools and implements do not
grind them for too long i.e. they should not be
7. Be aware of the tool support and do not jam
any material between the support and the
grinding wheel.
8. Cool materials regularly during use by dipping
them into water.
9.
stone.
10.
stone.
IMPORTANT! Never turn the grinder on when the
grinding wheel is in contact with the workpiece.
This may cause damage to the workpiece or
result in personal injury. The machine should be
running before contact is made to the workpiece.
the workpiece.