EN -17-
minimum position for 5 minutes, then open and close the oven door 2-3 times to check
the flame stability of the burner.
Changing the gas inlet
For some countries, the gas inlet type can be different for NG/LPG gases. In such a case,
remove the current connection components and nuts (if any) and connect the new gas
supply accordingly. In all conditions, all components used in gas connections should be
approved by local and/or international authorities. In all gas connections, refer to the
“Assembly of gas supply and leakage check” clause explained before.
Electrical Connection and Safety (If available)
WARNING:
The electrical connection of this appliance should be carried out by an
authorised service person or qualified electrician, according to the instructions in this
guide and in compliance with the current local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.
• Before carrying out the connection to the power supply, the voltage rating of the
appliance (stamped on the appliance identification plate) must be checked for
correspondence to the available mains supply voltage, and the mains electric wiring
should be capable of handling the appliance‟s power rating (also indicated on the
identification plate).
• During installation, please ensure that isolated cables are used. An incorrect
connection might damage your appliance. If the mains cable is damaged and needs
to be replaced this should be done by a qualified personnel.
• Do not use adaptors, multiple sockets and/or extension leads.
• The supply cord should be kept away from hot parts of appliance and must not be
bent or compressed. Otherwise the cord may be damaged, causing a short circuit.
• If the appliance is not connected to the mains with a plug, a multi-pole isolator
switch (with at least 3 mm contact spacing) must be used in order to meet the safety
regulations.
Thermostatic oven valve
Bypass screw
Non-thermostatic
oven valve
Bypass screw
