© 2011 Monte Carlo Fan Company
5/10/2012
6
Install all 5 fan blade assemblies to the motor
as shown above. Tighten screws securely.
Loosen 2 of the 3 screws that will hold the light
kit. Remove the screw that is associated to the
closed hole on the light kit.
29
30
Place blade arms onto the other side of the
blade and aligning holes. Insert screws with
fabric washers though the holes and tighten
securely.
28
Install the 2x50 watt halogen bulbs. Do not
touch bulb surface as oily residue from skin can
cause the bulb to explode. Bulbs included.
WARNING: Over lamping the fan will
result in the fan lights shutting down
until the proper wattage of bulbs are
installed.Reset the lights by turning off
the wall switch, breaker,or by remote.
Replace bulbs with the correct wattage
bulbs, turn the power on.
Lift light kit to the fan motor assembly. Align
the 3 screws with the key hole slot holes in the
light kit (see inset). Rotate the light kit as
shown. Then install the screw removed in the
previous step though the closed hole. Tighten
all 3 screws securely.
32
33
Twist light kit into place by turning
direction of arrow.
35
This step is for glass replacement
only.
Remove 1 glass holder and place
glass in decorative body of light kit.
Replace glass holder to hold glass in
place.
34
Plug white wire from fan to white
wire from light kit. Then plug black
wire from fan to black wire from light
kit.
31
Remove cover by snaping off from top or bot-
tom. Remove battery cover. Install 12V battery
into wall remote. Duracell MN21 / Eveready
A23 / GP 23A all 12V.Attach cover of remote
by placing over buttons and snap the battery
cover in place.
36
