Monte Carlo Fan Company 5MFR52 D Series, Руководство пользователя

Страница: 5 / 8

30
Connect white wire from
fan to white wire from light
fixture and then connect blue
wire from fan to black wire
from light fixture.
32 31
Install 3 x 40-watt G9 base bulbs. Bulbs
included. WARNING: Over lamping the
fan will result in the fan lights shutting
down until the proper wattage of bulbs
are installed.Reset the lights by turning
off, replace bulbs with the correct
wattage bulbs, turn the power on.
Note : Do not replace bulb until it cools
down.
Lift light fixture assembly up,
aligning its keyhole slots with the
screws on the plate and re-install
the screw removed in step 21.
Tighten all screws securely.
Remove finial and then remove
rubber washer and hex nut from
light fixture. Save parts for later
use.
34
Attached glass onto light fixture
a s s e m b l y a n d s e c u r e i t by
rubber washer and hex nut
removed in step 33.
35
36
Hang-tighten finial to secure
the glass.
Reverse feature of this fan is
controlled by a switch located on
top of the fan body. Turn off the
fan, and reverse the fan by slipping
the switch. This will reverse the
direction of the fan blades.
37
Remove battery cover. Install 12V battery
into wall remote. Duracell MN21 / Eveready
A23 / GP 23A all 12V.Attach cover of remote
by placing over buttons and snap the battery
cover in place.
38
Place face plate over battery compartment
and buttons. Place remote over 2 pins on front
cover. Attach cover of remote by placing over
4 pins and snapping into place.
HAND HELD INSTALL
39
Install wall control unit to outlet box
using machine screws provided.
WALL MOUNT INSTALL
33
40
Attach front cover to wall control
with screws provided. Snap battery
cover in place.
Note : If you want to add
a scene on an installed fan
(fan w/o scene), carefully
remove the glass and light
fixture from fan.
Install scene with the light
fixture as installation 28
and 29, then re-install the
light fixture assembly and
glass.