Monte Carlo Fan Company 5MFR52 D Series, Руководство пользователя

Страница: 4 / 8

21
24
20
L o o s e n t w o a n d r e m o v e o n e
preassembled screw from the plate
on motor assembly. Keep screw for
later use.
Install 3 x 40-watt G9 base bulbs. Bulbs
included. WARNING: Over lamping the
fan will result in the fan lights shutting
down until the proper wattage of bulbs
are installed.Reset the lights by turning
off, replace bulbs with the correct
wattage bulbs, turn the power on.
Note : Do not replace bulb until it cools
down.
Insert blade into the slot on flywheel and
install blade screws and fiber washers
aligning each of the holes as shown
(screws and washers provided). Tighten
screws securely. Repeat this process
for remaining blades. Note : Make sure
the side with a label “This side up” is
installed upward.
23
Align keyhole slots of the light
fixture with the screws on light pan
and twist counterclockwise till tight.
Re-nstall the screw which removed
in step 21. Tighten all screws
securely.
28
Place scene over light fixture,
aligning the holes with screw
holes on light fixture as shown.
27
Install finial to secure the
glass.
22
Connect white wire from fan to
white wire from light fixture,
then connect blue wire from fan
to black wire from light fixture.
Remove finial and then remove
rubber washer and hex nut from
light fixture. Save parts for later
use.
Attached glass onto light fixture
and secure it by rubber washer
and hex nut removed in step 25.
19
25
26
For fan without scene,
go to step 22.
For fan with scene, go
to step 28.
Lift Conopy allowing the 2 studs
to protrude through the canopy
and install knurled nuts as shown.
Tighten the knurled nuts securely.
The canopy should adjust for any
irregularity in the ceiling or Outlet
box.
29
Install 3 screws to secure
the scene with light fixture.
Screws provided.