Align keyslot holes of the light kit
plate and twist to lock. Install the
screw removed in step 22 and tight-
en all 3 screws securely.
Loosen 2 screws and remove one
screw from the light kit plate. Keep
the removed screw for later use.
23
24
Remove the finial nut, hex nut, and
rubber washer from the light fitter.
Keep them for later use.
25
Connect white wire from fan to white
wire from light fixture, then connect
the blue wire from fan to the black
wire from light fixture.
26
Aline keyslot holes of the light fixture
and twist it to lock. Install the screw
removed in step 24 and tighten
securely.
27
Attached the glass to the fan. Install
the rubber washer and hex nut which
removed in step 25 to the thread rod
and secure the glass.
29
Lift canopy and install knurled nuts as
shown. Tighten the knurled nuts securely.
The canopy should adjust for any irregu-
larity in the ceiling or Outlet box.
20
Check motor for shipping stabilizers and
remove if present. Attach blades using
screws and fiber washers in hardware
pack. Tighten screws securely. Repeat
this procedure 4 more times.
21
Loosen 2 screws and remove one screw.
Keep the removed screws for later use.
22
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box. The splices after being
made should be turned upward and pushed carefully
up into the outlet box.
19
Install 3 x 40 watt candelabra base
bulbs, Bulbs included.
warnInG:
Over lamping the fan will result
in the fan lights shutting down
until the proper wattage of
bulbs are installed. reset the
lights by turning off the wall
switch, breaker,or by remote.
replace bulbs with the correct
wattage bulbs, turn the power on.
28
Install the decorative finial nut to
the thread rod by screwing to
secure the glass.
30
