© 2011 Monte Carlo Fan Company
1/16/2012
5
Install 3 screws and fiber washers to back side
of blade as shown.
27
Hang fan from mounting bracket by
the hands free “S” hook in hardware
pack into a closed hole on the edge of
the canopy and over bracket.. Note:
For Canadian mounting refer to Step
#10.
24
Remove side covers to canopy.
20
23
Remove the all thread studs from the
lower part of the mounting bracket. Install
2 screws that align with the “L” shape
holes in the canopy into the mounting
bracket. (see step 15)
Screw for “L”
shape slots
Screw for “L”
shape slots
“L” shape
slots
Place canopy on top of the fan motor allowing the
yoke to pass through the large hole in the center of
the canopy. Align the 3 larger holes around the
center hole with the 3 screws already installed in
the fan. Install 3 flush mount screws removed pre-
vious step into smaller holes and tighten securely.
22
Canopy
Center
Hole
Larger
holes
Smaller
holes
Lift fan to mounting bracket, aligning the “L”
shape holes with the scresws on the mount-
ing bracket. Turn the fan clockwise to lock
in position. Install the other two screws and
tighten securely.
25
Remove 2 screws in yoke. Remove 3
screws (every other screw) from top of
fan.
21
Swing blade holders out and align hole with
arrow on blade holder with hole in blade with
arrow. Make sure that the side of the blade
that has the sticker this side up is facing up-
ward.
26
Pass leadwires and safety cable through
the canopy.
Steps 19-25 for flush
mount installation skip to step 26 if
using the downrod.
19
Flush Mount Installation
