Monte Carlo Fan Company 3VTR38D Series, Руководство пользователя

Страница: 3 / 13

8
7
Attahced remote receiver onto the motor
plate with the double stick tape in the
hardware pack. Press firmly to position
the remote receiver as shown.
Set dip switches on the Remote Transmitter and
Remote Receiver to the same settings. This must
be done so the units will communicate properly.
If you have other fans you can set to control from
one transmitter by setting both receivers the
same as the transmitter. If you have more than
one fan with remote. You can set the dip switches
to different positions to have seperate control.
9
Carefully lift the fan motor assembly and
engage the slot in the motor housing with the
hook on the mounting plate so that the motor
is securely suspended.
10
Make wiring connections as indicated above.
White from fan to white from remote marked N.
Blue from fan to blue from remote marked light.
Black from fan to Black from remote marked L.
White from house to white from remote marked
AC N . Black from house to Black from remote
marked AC L. Connect all green ground wires to
Grounded wire from House.
11
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the wire
connections, the wires should be spread apart
with the grounded conductor and the equipment-
grounding conductor on one side of the outlet
box and ungrounded conductor on the other side
of the outlet box. The splices after being made
should be turned upward and pushed carefully up
into the outlet box.
12
Lift the motor plate and aline its keyslot hole
with the screws on mounting plate and twist
clockwise till tight. Install the screw and
lock washer which removed in step 3 to the
mounting plate. Tighten all screws securely.
13
Aline the clips on the housing with the
holes in the mounting plate
14
Lift motor housing up and turn motor
housing clockwise to hold in position.
15
52" and 38" blades included. Choose the
blade you like. Attach blade to motor
with 2 screws provided, only start screw,
do not tighten the screws yet. Repeat for
the other blades installation then tighten
all screws securely.
16
Loosen 2 screws and remove 1
screw from the motor plate. Save
the screw for later use.
17
Connect white wire from fan to white
wire from light fixture, then connect the
blue wire from fan to the black wire from
light fixture.
18
Aline keyslot holes of the light fixture
with the screws on motor plate and twist
clockwise till tight. Install the screw
which removed in step 16. Tighten all
screws securely.
R e m o t e R e c e i v e r D i p
switches
Remote Transmitter
Dip switches