Montarbo EARTH 218, Руководство пользователя

Страница: 54 / 60

owner’s manual | Earth218
54
the preset management window is shown in the lower right corner.
the upper number indicates the active preset that may be set using the two arrow
buttons.
it is possible to save to the PC every adjustment made to the speaker's settings and then
recall them later and load them as the active preset.
once one of the factory preset options (numbered 1 to 4) or the user's preset (number
0) has been selected, it is loaded to the speaker's dsP by clicking
Run
and will become
active after a delay of a few seconds.
if the preset has been edited (modified by changing the equalizer's setting or the delay)
it can be saved on the PC hard disk by clicking the
SaveHDD button, or can be stored in
the speaker's dsP by clicking SaveDSP .
the OpenHDD button allows you to load a preset that has been saved on the PC's hard
disk (or on any other memory device) and make it the active preset.
Important : it is not possible to permanently modify the dsP's factory presets (numbers
1 to 4).
it is possible to permanently store in the dsP an edited (modified) preset only as a user
Preset (number 0).
to do so, follow this procedure: load one of the factory presets (1 to 4) and edit it (or
load an edited one from the PC, by clicking on openHd), then save it as preset number
0 by clicking on savedsP.
this way the modified preset will replace the dsP preset number 0, and it may be recalled,
even without the raConls program, by means of the speaker’s rear-panel pushbuttons.
so, if the speaker's selected preset is the number 0 (user Preset), it will be the default
preset at switch-on.
any future updated preset which may be made available from montarbo will be loaded
the same way: first saved on the PC as preset files, then recalled and stored as described
above.
raConls
™
software
MANAGEMENT OF PRESETS