Montarbo EARTH 218, Руководство пользователя

Страница: 36 / 60

owner’s manual | Earth218
36
PRODUCT CARE AND MAINTENANCE
• Never expose the enclosures to direct sunlight, excessive vibrations or
mechanical shocks.
• Never place burning candles or other sources of open flame on top of
the device. do not expose the enclosures to heat sources (lamps, lights,
high power light sources, radiators or other heat producing equipment).
• Avoid operating and storing the system in damp or dusty places: this
may lead to malfunctions and premature degradation of performances.
• Avoid using the system close to strong sources of electromagnetic
interference (e.g. video monitors, high power electrical cabling).
this may lead to degradation of audio quality.
• When setting up the system outdoors, be sure to protect it against
rain and moisture.
• Care should be taken to prevent small objects or liquids from falling
or spilling into the enclosure. in public events don't allow musicians,
technicians or anyone else, put glasses, cups, ashtrays or cigarettes on
the enclosures.
• Always leave the protective grid mounted on the enclosures.
• Use a soft brush or a jet of air to clean the enclosure. Do not use alcohol,
solvents or detergents.
• Take care of the connecting cables. Make sure that they are not
damaged, knotted or twisted.
• Do not force connectors and controls.
• As long as it is plugged in, dangerous electrical potentials may be present
inside the device, so, before undertaking any sort of maintenance work
etc., always make sure it has been unplugged from the mains socket.
SySTEM WIRING
AC mains connection
- make sure that the ac line voltage value corresponds to the one indicated
on rear panel.
- Connect the mains supply cable to a socket fitted with a proven ground
contact.
Wiring of signal cables
th
e input sockets in (4l) and (4r) and the linK sockets (5l) and (5r) are
Xlr 3 pole connectors, female (in) and male (linK).
they are wired according to ieC 268 (aes1492) standards:
pin 1 = ground, pin 2 = hot (+) , pin 3 = cold (-).
❯
Use only screened cables (signal cables) of suitable size and
quality.
❯❯❯
Connector wiring is illustrated in the following chart.
CONNECTORS WIRING
important
1 GND Ground
2 + Hot
3 – Cold
(ieC 268 standard)
balanced
xLR female connector
balanced
xLR male connector
balanced
xLR male connector
balanced
xLR female connector
➔
➔
LINK R
IN R
X-OVER OUT R
LINK L
IN L
X-OVER OUT L
POWER AC LINE IN
15A
AC LOOP OUT
IMAX 5A
Power Consumption
1700W
I
0
1
2
3
4
User
Both = Enter
UP
DOWN
VOL.
Preset
sig clip thw prot
DATA
85 – 264V
~
50/60Hz
NEUTRIX
3
1 2
NEUTRIK
PUSH
3
1 2
NEUTRIK
PUSH
PUSH
3
2 1
NEUTRIK
3
2 1
NEUTRIK
3
2 1
NEUTRIK
3
2 1
NEUTRIK
NEUTRIX
PUSH