Montarbo 215 SA, Инструкция по эксплуатации

Страница: 10 / 23

215 SA
10
Control and connection panel
LIFT
FUSE F
5 A
230V
50/60Hz
GND
P O W E R E D P R O C E S S O R C O N T R O L L E D
Montarbo 215 SA
MOD.
P O W E R
800W
INPUT
LEVEL
2
7
6
5
4
9
10 0
8
3
1
I N P U T X - O V E R O U T
FLAT
L I N K
R / mono
100Hz 20KHz
L
R R
L L
S T E R E O S U B W O O F E R S Y S T E M
4
2
1
6
7
8
5
Fuse replacement
Service fuse
Spare fuse
6 Ground /Lift switch: this switch allows to lift signal
ground from chassis ground (but the chassis is still
connected to the safety ground). This allows to lower
annoying hums caused by "ground loops" when more
units are connected.
7 Mains power switch.
8 I.E.C. power supply socket with built-in fuse.
3
1 Flat / X-over switch allowing the "satellite" speaker
systems, connected to the stereo output (2), to receive a
full-range signal or the upper audio range only. In both
conditions the signal is affected by the volume control (5)
☞
Button up (crossover off) = "flat" mode: the output
signal is "full bandwidth".
☞
Button pushed (crossover on) = "x-over mode":
100Hz
÷
20kHz high pass filter output signal (100Hz,
24dB/ oct.).
NOTE : To avoid misoperation, this button is recessed:
use a tip (pen or pencil) to switch it.
2 2 unbalanced XLR male sockets for the stereo output.
3 2 balanced XLR female sockets for the stereo input.
4 2 balanced XLR male sockets (Link) for parallel
connection of active speaker systems.
☛
See connectors and connection examples from
page 17 to 21 .
5 Input level control.
Allows to adapt the input sensitivity of the built-in power
amplifier to the output level of the mixer.
If you are using a Montarbo mixer (or any other mixer
having an output level of 0dB), turn this control fully
clockwise to its maximum setting.
ENGLISH