Monster Vision MAX 3D, Руководство пользователя

Страница: 19 / 32

17
4.3.2.1 Detecting a Signal
1. Turn on your 3D TV.
2. Place TV into 3D Mode (refer to TV owner’s manual for how to turn 3D on).
3. The transmitter LEDs will display a
RED moving pattern while the
transmitter attempts to acquire a 3D signal, this will continue until
it detects a 3D signal.
Should the transmitter not acquire a 3D signal within 60 seconds, repeat steps 1 and 2.
Upon finding a 3D signal, all LEDs turn
GREEN .
You are now ready to enjoy 3D viewing with your MAX 3D Eyewear...
The MAX 3D Transmitter is preprogrammed and configured to operate with 3D TVs that have a
3D Sync Port. If the image, when viewed through your MAX 3D Eyewear, is fuzzy, ghosted, or out
of polarity, see section 5.1 Basics of Fine Tuning on pg. 22.
NOtE: “Out of polarity” can look 2D or flat. It refers to the display of a left eye image while the right
lens is opened or display of a right eye image while the left lens is opened.
4.3.3 Connecting to TVs for IR Sync (No 3D Emitter Port)
1. Place the Monster Vision MAX
3D IR sensor near the built-in 3D
transmitter of your 3D TV.
Diagram shows likely location;
consult your TV owner’s manual for
exact location.
2. Connect the 3.5mm jack on the
IR receiver cable to the IR Sync
connection on the transmitter.