Monster Vision MAX 3D, Руководство пользователя, Страница: 15 / 32

13
3.2.1 Checking the Battery Level
1. Press and hold the button until the red LED comes on, then release the button.
2. The LED will blink in a pattern as described below; the LED will blink shorter and slower,
the more charge the battery has.
Blink Activity After Power-on Blink Blink Activity After Power-on Blink
2 long blinks 50% or more, 20 hours or more remains.
6 medium blinks 10% or more, 4 hours or more remains.
12 fast blinks 10% or less, eyewear will require charging before
the end of a long movie.
Power on indicator never blinks Battery is completely discharged; eyewear needs
to be charged before use.
NOtE: LED will flash in a slow Heart beat indicating a full battery charge while the eyewear
is connected to the power source.
3.2.2 Auto Power Shutdown
• If your MAX 3D Eyewear unit does not detect a MAX 3D Transmitter, its LED will blink
on and off once per second for 5 minutes and then power off automatically.
• If the MAX 3D Transmitter is active (because the TV is in 3D mode) before the 5 minute
period expires, the eyewear unit will stop blinking and remain on.
3.2.3 Resetting Eyewear Transmitter Sync
Under normal conditions the eyewear will not be reset, however if the need arises to connect
to a different transmitter, then the sync between the units needs to be reset.
To Rest Your Max 3d Eyewear Unit
1. Press and hold the power button.
2. After 1 second, the LED will light up.
3. Release the power button.
The LED will blink as indicated in the section 3.2.1 Checking the Battery Level on pg. 13
and will look for a transmitter that is in sync with a TV.
3.2.4 Restoring Factory Defaults
iMPORtANt:
Please read through the following steps before proceeding, the operation
is time sensitive.
Should for any reason the Eyewear not be perform correctly and other troubleshooting methods
fail, the firmware can be restored to factory defaults. This will clear any information in the Eyewear
and allow it to perform at its optimum level.