Monogram ZV36SSJSS, Руководство по установке

Страница: 13 / 18

31-2000859 Rev. 0
13
STEP 2B Alternate Mounting Method
INSTALL HOOD TO SOFFIT OR BENEATH CABINETS
IMPORTANT: Soffit framing must be capable of supporting up to 150 lbs.
SKIP THIS STEP IF USING WALL MOUNTING
METHOD
:KHQQHFHVVDU\WKHKRRGPD\EHLQVWDOOHGVRWKDWLWLV
supported by the soffit.
‡7KHVRIILWVKRXOGEHFRQVWUXFWHGZLWK[¶V
• Determine the installation location on the wall.
• Continue the centerline forward on the bottom of the
cabinet or soffit.
• The opening above the hood should allow for the
10” round duct and clearance to slide the hood back
against the wall.
‡7KH[VWXGVPXVWEHORFDWHGDVVKRZQLQWKHFKDUW
'LP$WRDFFHSWPRXQWLQJVFUHZV
• Drill 1/8” pilot holes into the studs at the locations
shown in the top view illustration.
• Use duct tape to seal the transition duct connection.
Check to be sure the damper moves freely.
Mount Hood onto Soffit or Cabinet
NOTE: If mounting to the underside of a cabinet with a
UHFHVVHGERWWRPLQVWDOOVKLPVWRILOOWKHJDS
• Drive mounting screws into the studs until they
protrude 1/4”. The 1/4” gap will provide clearance to
engage the keyhole slots in the top of the hood.
• Lift hood to installation position. Locate house wiring
and route through the knockout (from the back or top
of the hood).
• Lift hood onto mounting screws. Slide back against the
rear wall.
• Tighten mounting screws.
IMPORTANT: For additional support and to
minimize vibration during operation, the hood
must be secured to the back wall. Use wall
anchors to fasten bottom back of hood to the wall.
Installation Instructions
A
Requires 10-1/2" Min.
Opening For Ductwork
and Hood Installation
A
“A” Centerline
to Stud and
Keyhole Slots
“B” Hood Width At
the Top
ZV48T 19-9/16" 40"
ZV48S 23-9/16" 47-15/16"
ZV36T 13-9/16" 28"
ZV36S 17-9/16" 35-15/16"
ZV30T 10-9/16" 22"
ZV30S 14-9/16" 29-15/16"
2"
7-1/2"
A
B 2-9/16"
10"
3/4"
Back of Hood
Top View
Front of Hood
1/4" Gap
Push Back
to Wall
Add Shims
If Bottom
Is Recessed
Back
Wall
Cabinet
or
Soffit
Engage Top
Keyhole Slots