Monogram ZICS360NHLH, Руководство по установке

Страница: 22 / 28

22
Installation Instructions
STEP 14 ATTACH BRACKETS TO
FREEZER DRAWER PANEL-
FLUSH INSTALLATION ONLY
The Freezer Drawer panel will have 4 of the bottom panel
brackets installed in 4 places on the back of the panel.
1. Align the four tapered holes in 1 bottom panel
bracket with the four pilot holes in one corner of the
Freezer Door panel making sure the angled portion of
the bracket is facing the closest edge, left or right, of
the panel. Fasten the bracket using four screws.
2. Repeat with the other 3 bottom panel brackets in the
3 remaining corners.
3. Install the custom handle on the front side of
the door panel. A washer should be used in the
countersink hole on the back of the panel.
Top Back of
Panel
The Freezer Panel is face
down on a non-scratch
surface.
STEP 15 HANG DECORATIVE DOOR
AND DRAWER PANELS- FLUSH
INSTALLATION ONLY
Panels with attached brackets will mate with steel
brackets already attached to top, sides, and bottom
of refrigerator door and freezer drawer. Each bracket
attached to the door and drawer will have two
machined screws recessed inside the door to provide
anchoring points for wood panel brackets.
1. Lift the door panel to
hang the panel on the
door. Angle the bottom
of the panel slightly
away from the door. The
brackets mounted at the
top of the door panel will
lay over the top of the
brackets mounted at the
top of the door. Allow
the flanges of the door
brackets to slide into
the slot at the top of the
panel brackets and gently allow the bottom edge of
the panel to lay against the door as it hangs freely.
STEP 15 HANG DECORATIVE DOOR
AND DRAWER PANELS- FLUSH
INSTALLATION ONLY (Cont.)
2. Adjust the panel on the door by pushing it flush
against the door.
3. Using supplied washer-head screws, secure panel
brackets mounted to the rear of the wooden panels
to the refrigerator door; top, side and bottom.
Each screw should be tightened until snug, and
then backed off 2-3 turns to allow for fine tuning
adjustment. NOTE: If screws are fully tightened at
this stage, further panel adjustment will not be
possible.
4. Thread set screws into each of the panel brackets
attached to the doors. Hinge side brackets will have
2 set screws each, going into the door. The handle
side brackets will each have 1 set screw going into
the door. Each panel bracket has a tab that is aligned
with a tab on the door bracket. Each of these will
have a set screw threaded into them (see illustration).
Bottom Panel
Bracket
Bottom Panel
Bracket